TRANSPORTATION AND HANDING
Please move the appliance without tilting. Adjust the 2 front feet until clear of the flooring
before maneuvering.
Never hold the door handle as support. Never position it upside down or horizontal.
INSTALLATION
THIS APPLIANCE MUST BE PLUGGED INTO AN EARTHED SOCKET.
DO NOT USE AN EXTENSION REEL WITH THIS APPLIANCE .
1. Do not site in a location which is likely to drop below 5 degrees centigrade, i.e. an unheated
garage or shed in winter.
2. Install the refrigerator on flat, firm ground to prevent vibration and noise.
3. Choose a dry and well-ventilated location. A space of no less than 10cm must be left
around the refrigerator.
4. Choose a location where there is no heat source. Keep the refrigerator away from direct
sunlight, radiators, heaters and oven etc.
5. Adjust the front feed to achieve vertical alignment.
6. Allow to stand for 2-3 hours after moving before plugging in to mains.
BEFORE USING
1. Clean all parts of the refrigerator with lukewarm water containing a little mild detergent,
wipe dry.
Notes: Do not wet electric parts.
2. Turn the thermostat knob to the "3" position and turn on electricity. The compressor and the
light inside the refrigerator will begin to work.
3. Close the door and leave for 30 minutes. If the temperature in the freezer compartment has
decreased noticeably the refrigerator is working normally.
TEMPERATURE CONTROL
1. The temperature in the refrigerator and freezer compartment is controlled by the
temperature controller installed on the roof of the refrigerator compartment.
2. The marks on the knob are setting guides, NOT the exact degrees of temperature.
'0' is 'OFF' and "5" represents the lowest temperature.
3. Please start with the knob set to position "3". The refrigerator temperature should be set
between +2ºC and +5º and the freezer will vary between -18 and -25 degrees centigrade
over a typical cycle. To reduce the refrigerator temperature turns the knob towards '4' and
check after one hour.
-12-
ENGLISH