Publicidad
Idiomas disponibles
Idiomas disponibles
EN
and stop the engine.
In this case, please repair the machine
at your nearest servicing dealer.
CUTTING WORK
Weather conditions and altitude may
effect carburetion.
Do not allow anyone to stay close to the
hedge trimmer while working or while
adjusting the carburetor.
HOW TO USE: HANDLE
To reduce fatigue when trimming
hedges, the handle can be swiveled
through 90° to the left or right.
Do not press the throttle during this
operation!
Proceed as follows:
1. Free the handle by pressing the
locking lever.
2. Turn the handle until the locking
lever clicks into place.
3. When the handle is locked in its
new position, you can apply the
throttle again.
30
(1) Handle
(2) Locking lever
You can swivel the handle even with
the engine idling because the hedge-
trimmer is equipped with a blade
brake that maintains the blades at a
standstill.
HEDGE
TRIMMING
TECHNIQUES
Trim sides of a hedge first, and then
the top.
With the single-sided
VERTICAL CUT:
blade hedge-trimmer, model GJB-25S
always cut from the bottom up.
With the 2-sided blade model GJB-
25D use an arcing cut from the bottom
upwards, then downwards to use both
sides of the blades.
HORIZONTAL CUT:
get the best cutting results, slightly
tilt the blade (5÷10°) towards the
cutting direction.
Cut slowly, especially with thick
hedges. Always follow the safety
precautions.
The hedge-trimmer must only be used
to trim hedges or small bushes. It is
forbidden to cut other types of material.
Do not use the hedge-trimmer as a
lever to lift, move or
break objects, nor lock it on fixed
supports. It is forbidden to apply tools
or applications that are not the ones
indicated by the manufacturer onto the
hedge-trimmer's power take-off. Do not
use it for pruning trees or cutting grass.
Use only as much throttle as is needed
to do the job. Excessive engine speed is
unnecessary.
Avoid cutting thick branches, for
which will damage the blades and
shorten the life of drive systems.
Tilting the trimmer 5 to 10° to the
cutting object will make the job easy
and bring a good result.
Always keep your body to the
carburetor side of your trimmer,
never on the muffler side.
When a new machine is first
operated, in the first few minutes
grease may come out of the gear
case. But, since this is excess
grease, there is no cause for alarm.
Just wipe it off with the engine
stopped for next use.
Always remember that the TIP of the
line does cutting. You will achieve
better results by not crowding the
line into the cutting area. Allow the
unit to trim at its own pace.
MAINTENANCE
Make sure that the engine has
stopped
performing
machine.
cutting head or hot muffler may
result in a personal injury.
In order to
BLADE
Check the blade and the fasteners
for looseness, cracking, or bending.
Check the cutting edges and reform
with a flat file. Point :
1. Keep the end corner sharp.
2. Round the root of the edge.
3. Do not use water when using a
grinder.
You need not to adjust the gap
between upper blade and lower
blade as this product is designed to
have optimal gap when it is properly
set up.
and
is
cool
before
any
service
to
the
Contact
with
moving
Publicidad
