Publicidad
Idiomas disponibles
Idiomas disponibles
EN
English
that it will not drape over the counter top or table top, where it can be pulled
on by children or tripped over.
USING THE PRODUCT FOR THE FIRST TIME
1. Remove the packaging material and remove any stickers.
2. Make sure that the filter is installed in the kettle.
3. When using the product for the first time, clean it as described in the
"Cleaning and maintenance" paragraph.
4. Connect the power base to a socket.
5. Fill the kettle with cold tap water up to the maximum level "MAX". Boil the
water and discard it. Repeat this operation two or three times.
6. Now the kettle is ready for use.
USING THE PRODUCT
NEVER plug the kettle in when it is empty.
DO NOT use the appliance for purposes other than boiling water.
Other liquids may contaminate the inside of the kettle.
DO NOT fill the kettle when it is on its power base already plugged in.
DO NOT fill the kettle beyond the MAX level indicated on it. Overfilling
may cause water to spill out when it boils.
DO NOT attempt to connect other appliances to the power base or
tamper with the connector in any way.
1. Place the power base on a flat, dry and heat-resistant surface.
2. Open the lid by pressing the lid release button and fill with water up to the
minimum level "MIN" (0.75 L).
3. Close the cover.
4. Place the kettle on its base and make sure that it is securely hooked in
place.
5. Plug the power base into a socket.
6. Direct the kettle spout away from furniture, walls, etc., to prevent damage
from steam.
7. Press the power button "I" on the lid: the white indicator light, which can
be seen through the water level window, will light up. This light indicates
18
that the boiling cycle has started. When the water has boiled, the light
turns off and the kettle switches off. To switch the kettle off at any time,
press the stop button "O".
IMPORTANT:
• The kettle switches off automatically when the boiling cycle is complete.
• If the kettle is removed from its base before the boiling cycle is complete,
the kettle will switch off automatically.
• To switch the kettle off before the end of the boiling cycle, press the stop
button "O".
DO NOT open the lid when the kettle is hot.
If you want to use the kettle again, allow the safety thermal switch to
cool down for 60 seconds, then press the power button "I".
If the kettle is switched on by mistake when it is empty, the thermostat
will automatically perform an on/off cycle to prevent overheating. If
this situation occurs, press the stop button "O" and unplug the kettle
immediately. Allow the kettle to cool down before refilling it.
8. After use, put the kettle back on its base or on a heat-resistant surface.
9. Unplug the power cable when not in use.
ONE CUP DISPENSING MODE
1. Follow steps 1-6 in the "USING THE PRODUCT" section.
2. Place the drip tray in front of the water dispensing door (see fig.1).
3. Open the water dispensing door by pressing the button with the " ".
4. Place a cup on the drip tray. IMPORTANT NOTE: A cup must ALWAYS
be placed on the drip tray when the water dispensing door is
open.
5. Select the desired cup size by turning the knob around the power button
and press the power button "I".
6. When the water boils, it is automatically poured into the cup from the
water dispensing door and the kettle switches off.
IMPORTANT:
• The kettle switches off automatically when the boiling cycle is complete.
• To switch the kettle off before the end of the boiling cycle, press the stop
button.
English
19
EN
Publicidad
