Atlas Copco ETV STB63-70-B13-B Instrucciones Del Producto página 6

Safety and operating instructions
Maintenance
Lubrication
Planetary gears, needle bearings and ball bearings must be lubricated with soft grease containing molyb-
denumdisulphide at the regular overhaul of the tool.
Take care to use specified quantity. Too little as well as too much will cause problems.
Lubricating guide
Brand
Molycote
CRC
Brand
Molycote
Almagard
Overhaul
Have your power tool serviced by a qualified repair person using only identical replacement parts. This
will ensure that the safety of the power tool is maintained.
Service must only be carried out by qualified personnel who have access to the Service instruction and/or
have been trained for service on Tensor STB Tools.
The electric motor is a sealed unit and may under no circumstances be opened by anyone else than Atlas
Copco Industrial Technique AB!
If it is judged that the electric motor is defect or in need of service, the complete motor unit should be re-
turned to Atlas Copco Tools for exchange.
Motors which have been opened by anyone else than Atlas Copco Tools will not be serviced.
Overhaul and preventive maintenance is recommended at regular intervals once per year or after maxi-
mum 250.000 tightening depending on which occurs sooner. More frequent overhaul may be needed if the
machine is used in heavy-duty operations. If the machine not is working properly, it should immediately be
taken away for inspection.
When dismantling the tool always use the specially designed service tool 4080 0848 80, (two service
tools are required).
Useful information
Log in to Atlas Copco www.atlascopco.com
6
EN
Cable nut
Litium grease No. 3020
Angle gears
Longterm 2 plus
© Atlas Copco Industrial Technique AB - 9836 9000 00
ETV STB63-70-B13-B
Gears
BR2 Plus
General purpose
LE 3751