Allen + Roth VFS2-AR30DTL Manual De Instrucciones página 14

INSTALLATION
BATTERY INSTALLATION
Step 1 – Locate the Push Button Ignitor by lowering the cover on the bottom of the stove. (Fig. 1)
Step 2 – Unscrew the cap on the Push Button Ignitor with your fingers by turning it counterclockwise.
(Fig. 2)
Step 3 – Insert the battery with the positive (+) side facing forward.
Step 4 – Replace the cap by turning it clockwise until the cap is finger tight.
Push Button Ignitor
LEG INSTALLATION
Before installing the heater, follow these steps for leg installation.
1. Set a blanket or cardboard on the floor to create a padded surface.
2. With assistance, carefully place the stove upside down onto the padded surface.
3. Align the holes in the legs with the two (2) Threaded Studs shown in Figure 0.1 and slide
them in place.
4. Using the 8 nuts included with this manual, secure the legs to the threaded studs with a
wrench (not included).
DO NOT OVERTIGHTEN.
5. Repeat steps 3-4 to install the other three (3) legs.
6. With assistance, lift the stove off of the padded surface, and set upright onto the newly installed legs.
Push Button
Ignitor
Cover
Figure 1
Figure 0.1
AAA Battery
Figure 2
Nut
13
Push Button
Cap
Threaded Studs