Beta 680/3 Manual De Uso E Instrucciones página 16

OPERATION MANUAL AND INSTRUCTIONS ISTRUZIONI PER L'USO
Reset Button
- Press to reset value
- Hold to enter VERSION SCREEN:
In this function, data about the dynatester model being used will be displayed:
P/N: Part number
S/N: Serial number
S/W: Software version number
- Press to go back to the measurement screen
to enter SET UP MENU:
- Press
- to select a parameter
- to confirm the selected parameter
- to select the setting
- to confirm the selected setting
Settings options
Parameter
Language
LCD contrast
LCD Invert
Zero
Beep
Active Form
Resetting
Resetting is only required if the dynatester is not reset in the Track mode. In this case, the transducer
may have been overloaded.
If reading is unstable, the dynatester must be returned to Beta Utensili S.p.A.'s repair centre to be fixed.
The dynatester should be recalibrated as soon as possible after being reset.
While resetting the dynatester, check that no torque is applied, and remove any tools from the transducer.
16
en / fr / de / it / da / es / fi / sv / no / pt
1 – 255 (Default 160)
Inverting (√) or non-inverting (x)
Clearing, reset stored zero value
Enabled (√) / Disabled (x)
2.0 to 40.0 % (default 2.0%)
Possible settings
EN I