Orima ORT 6018 Manual Del Usuario página 19

CUPBOARD MOUNTING INSTALLATION
Drill a 130mm diameter and four 3.5mm diameter hole as below picture.

ATTENTION: If your cooker hood works at circulating-air mode, it is not necessary

to drill 130mm diameter hole.
Use the 4 screws to fix the cooker hood to a kitchen cupboard .Check that your

fixings are correctly located, by temporarily fitting the cooker hood. If correct, fit the
unit into position. Tighten the screws if necessary.
WALL MOU NTING INSTALLATION
To mount on the wall, drill two10mm diameter holes 538mm with the vent hole on

the top of the cooker hood in the middle as below picture. Make sure the hood is aligned
directly over the hob.
Insert two plastics wall plugs(supplied) into the holes.

Insert two screws into the upper two plastic wall plugs and tighten them leaving 3mm

protruding from the wall.
 Mount the cooker hood onto the two screws and mark the bottom two screw positions.
Remove the hood and drill the bottom two screw holes and Insert the plastic wall plugs.

Mount the hood on the top screws, Insert the bottom screws and fully tighten all the screws.

480
70
100
180
538
130
EN-7