Publicidad
Repair
Use only parts and accessories recommended by the
manufacturer. In the event that the tool does not work, the
repair must be carried out by any
Authorized Service Center.
Change of carbon brushes
• It is necessary to replace worn carbon brushes (burnt,
broken or less than 5 mm long), with new carbons.
• When changing carbon brushes, both carbons must
always be changed.
• Use a screwdriver to remove the cover of the carbon
brushes.
• Remove worn carbon brushes from the brush holder and
remove accumulated dust with compressed air.
• Place new carbon brushes s in reverse order. The carbon
brushes should fall into the coal holders easily.
• After fitting the new carbon brushes, allow the multi-tool
to run for a few minutes without load so that the carbons
have a better fit.
• Only original replacement carbon brushes should be
used, specifically designed with the appropriate hardness
and electrical resistance for each type of motor. Out of
specification carbon brushes can damage the engine.
Storage
Store the tool neatly in a dry place protected from dust
and water.
Maintenance
• Always unplug the tool before cleaning it.
• Never use water or other liquids, only use a brush.
• To prevent the motor from overheating, you should
clean the ventilation slots on a regular basis.
• Check that all the components of the tool are well fixed.
• The casing must not be cracked or damaged.
• Always check that the cable is not cut or frayed.
• After prolonged use, the grease in the head of the tool
must be changed at a
Center.
10
ENGLISH
Authorized Service
Maintenance
Publicidad
