Kohler 1032705 Manual De Instalación

SERVICE KIT INSTRUCTIONS
PURPOSE
The Kohler deep rough-in kit enables Kohler 3/4" high flow
deck mount hardware trim to be used on finished decks that
are thicker than planned.
NOTES
The standard Kohler highflow deck mount handle trim can
D
be adjusted ±1/4" (6mm) for finished deck variation. This kit
provides an additional 1/2" (1.3cm) of adjustment.
The standard spout supply tube is long enough for the extra
D
1/2" (1.3cm) of finished deck thickness.
PRODUCT REQUIREMENTS
Use this kit with 3/4" highflow deck mount bath valves.
INSTALLATION
Measure the installed valve height as shown below.
D
With the deck height known select the kit parts from the
D
following table.
Install threaded bonnet assembly from the kit onto the valve
D
bodies as needed.
Select and press the correct stem extensions on the valve
D
stems and secure with the appropriate screws.
Kohler Co.
DEEP ROUGH-IN KIT
1032705
1
Bonnet Assembly
Kit Provides For
1/2" (1.3cm) More
Material
1-3/4" (4.4cm)
Max. Finished
Deck
Original Planned
Finished Deck
Install handles and spout according to the installation
D
instructions.
Kit Parts
Valve height above finished deck:
*1-5/16" (3.3cm) to *1-1/2" (3.8cm) to
1-1/2" (3.8cm) 1-11/16" (4.3cm)
use following parts: use following parts:
Spacer
#8- 32 x 5/8" Screw #8- 32 x 1/2" Screw
11/16"
7/8" (2.2 cm)
Stem Extension
Stem Extension
Bonnet Assembly Bonnet Assembly
Spacer
Screw
Stem Extension
Spout Supply
Tube
*1-11/16" (4.3cm) to
1-13/16" (4.6cm)
the following parts:
Spacer -
#8- 32 x 7/8" Screw
1-1/16" (2.8cm)
(1.7 cm)
Stem Extension
-
1031241-9-A
*Valve
Height