Project Source H90K-51D-PS-BN Manual De Instrucciones página 4

INSTALLATION INSTRUCTIONS
1. Shut off the water at the supply valves under the sink or at the
main water supply. Disconnect the supply lines. Remove the
existing faucet from the sink.
Clean and dry the surface area where the new faucet will be
mounted.
2. Before installation, remove the preassembled lock nut (AA) and
washer (BB) from the shank (2.1) on the faucet body (A).
3. To install with the optional deckplate for a 3-hole sink, skip to
Step 4.
Before installation, make sure the flange (3.1) is on the bottom
of the faucet body (A). Carefully insert the water lines (3.2) and
shank (3.3) on the faucet body (A) through the mounting hole in
the sink (3.4). Skip to Step 5.
4. OPTIONAL DECKPLATE INSTALLATION:
The optional deckplate (B) and gasket (C) cannot be installed
with the flange (see 3.1 above) on the bottom of the faucet body
(A). Apply a thin bead of silicone to the underside of the gasket
(C). Place the gasket (C) and deckplate (B) over the mounting
holes in the sink, aligning the center holes in the gasket (C) and
deckplate (B) with the center mounting hole in the sink (4.1).
Carefully insert the water lines (4.2) on the faucet body (A)
through the hole in the deckplate (B) and the mounting hole in
the sink (4.1) until the faucet sits on top of the deckplate (B).
4
1
2
2.1
BB
AA
3
3.1
3.4
4
4.1
A
A
3.3
3.2
A
4.2
B
C