Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS (Continued)
5.
From underneath the sink, secure the faucet body (A) to the
sink using the washer (BB) and lock nut (AA).
NOTE: It is helpful to have a second person hold the faucet in
place while tightening the lock nut.
Hardware used
Lock Nut
AA
Washer
BB
6.
Attach one end of each of the water supply lines onto the
shanks (6.1) on the faucet body (A), with hot water on the left
and cold water on the right. Use 1/2 in. IPS faucet connections
(6.2) or supply line coupling nuts (6.3) with 3/8 in. OD ball-nose
risers (6.4).
NOTE: Do not reuse existing supply lines. When installing
new water supply lines, please refer to the supply line
manufacturer's installation instructions.
Tighten the supply line connections using two wrenches. Place
the first wrench on the shank on the tube (6.1) to hold it in
place while tightening the supply line with the second wrench.
This will help prevent twisting of the tubing. Do not overtighten.
Repeat for the second tube and supply line. Use caution when
tightening the connections, as the lines can crimp or break,
causing a leak.
7.
Attach each of the remaining ends of the water supply lines
(7.1) to the hot and cold shut-off valves (7.2) and tighten with a
wrench. Do not overtighten.
8.
Once the installation is complete, remove the spray head (8.1)
from the spout (8.2) on the faucet body (A) to flush the water
lines. Turn on the water supply and allow both hot and cold
water to run for at least one minute to flush away any debris
that could cause damage to internal parts. While the water is
running, check for leaks. If a leak occurs, gently tighten the nut
on the connection that is leaking. Turn off the water and screw
the spray head (8.1) back onto the spout (8.2) of the faucet
body (A).
x 1
x 1
10. 1
A
5
5
A
BB
AA
6
6.1
6.4
6.2
6.3
7
7.1
7.2
8
8.2
8.1
A
8.3
Publicidad
