Metra Electronics AXXESS AXPIO-JL1 Instrucciones De Instalación página 3

Pioneer Modular DDIN radio provision
1. Secure the radio display to the modular
radio brackets using (6) screws supplied
with the radio. (Figure A)
Note: Reference the aftermarket radio's
installation manual to determine which
screws secure the radio display.
2. Secure the radio chassis to the radio
display/bracket assembly using (4)
screws supplied with the radio. (Figure B)
Note: Reference the aftermarket radio's
installation manual to determine which
screws secure the radio chassis.
3. Route the RGB extension cable from the
radio chassis to the display screen, then
connect the cable to the display screen.
KIT ASSEMBLY
(Figure A)
(Figure B)
4. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or Axxess.
5. Reconnect the negative battery
terminal and test the Pioneer radio for
proper operation.
6. Place the radio display into the dash, and
then secure using the factory screws.
7. Attach (4) panel clips provided with this
kit onto the radio bezel, then snap the
bezel over the radio. (Figure C)
8. Reassemble the dash in the reverse
order of disassembly to complete
the installation.
(Figure C)
REV. 10/14/22 INSTAXPIO-JL1
3