Metra Electronics AXXESS AXPIO-JL1 Instrucciones De Instalación página 5

1. Remove (1) Phillips screw located above the window switches. (Figure A-1, B-1)
2. Using a panel removal tool, unclip the entire instrument panel trim. (Figure B-2)
3. Disconnect the wiring harness connector, then unclip and remove the Media
Hub from the backside of the panel. (Figure C-1)
4. Plug in the AXUSB-RAM1 and route the harness to the radio location.
Note: A Micro HDMI to HDMI cable (sold separately) is necessary, if HDMI input
is desired.
Attention! USB Type-C adapter may be necessary. This is supplied with the
Pioneer Radio.
Note: Refer to the Pioneer Radio installation manual.
5. Once the AXUSB-RAM1 is installed, this portion of the dash can be reassembled.
AXUSB-RAM1 INSTALLATION
(Figure A)
(Figure C)
(Figure B)
REV. 10/14/22 INSTAXPIO-JL1
5