Publicidad
Idiomas disponibles
Idiomas disponibles
2. Connect the male end of the included Plug-n-Play HWK-
TW01-HAR to the vehicles factory ODB II connector (Fig. A).
Fig. A
4. For the Nut and Bolt style mounting system: Place the left ear of the connector over the left factory stud and replace and tighten
the 8mm nut removed in step 1. Secure the right ear of the connector to the under dash using the included self tapping screw (Fig.
C).
For the clip in style mounting system: Feed the body of the harness into the dash opening and secure connector to the dash using
the included self tapping screws (Fig. D).
Fig. C
5. Remove the A-Pillar trim panel; this may require the removal of 2 x 10mm bolts. Route the Thinkware power cable over to the
driver side of the vehicle, up the A-Pillar (Fig. E) and across the front of the headliner (Fig. F & G) so that it exits the headliner at
the factory notch above the rearview mirror. NOTE: When routing cables near the side curtain airbag, be sure to route them
in a way that will not impact the airbags' ability to deploy in the event of an accident.
Fig. E
For assistance, please contact Echomaster at fordsupport@echomaster.com or call (866) 766-2267
3. Secure the OBD II connector and the harness together
using one of the included wire ties and cut off any excess wire
tie that is not needed (Fig. B).
Fig. B
Fig. D
Fig. F
Fig. G
Page 2 of 4
Publicidad
