Be Cool easy Manual De Instrucciones página 22

system manufacturer if in doubt about
EN
this point.
Do not use the safety seat in the forward
facing position before the child is 15
months old and has reached a height of
76 cm .
The safety seat must not be installed in
the rearward facing position on a vehicle
seat fitted with an airbag..
Keep the instruction manual for future
reference.
www.babybecool.es
42
1. ROTATION FUNCTION
1_ As shown in the figure, with the thumb to pull the
rotation limit handle, you can rotate the body of the
chair, you can rotate it left and right.The effect is shown
in the figure. After completing the rotation, release the
rotation limit handle and the handle will bounce back to
the initial position.
Important: the seat cannot be used in the sideways
position or rotated while driving. The seat must be
secured in the forward facing or rear facing position
before starting any car journey..
2. INSTRUCTIONS FOR USE OF INNER
CUSION
1_ Only for height less than or equal to 60cm
_Inner cushion _ Cushion _ Booster seat
3. I-SIZE UNIVERSAL (40-105cm): ISO-
FIX+ Top tether + five-point safety belt
Attention
A_ Suitable for models with ISOFIX systems which
pass ECE R14 .
B_ This I-size seat is installed backward, suitable
for 40-105cm children. Only one seat can be
adjusted in the first position.
C_ I-size seats cannot be installed in places with
airbags.
D_ "IMPORTANT-DO NOT USE FORWARD FACING
BEFORE THE CHILD'S AGEEXCEEDS 15 months
(Refer to instructions)"
D_ Important - The seat should not be used latera-
lly in the driving condition.
I-size (40-105cm)ISOFIX installation (backward
installation)
When installing backward, please use the backward
protection system.
1_ Please rotate the seat to the backward position first,
then pull the seat handle and adjust the sitting position
to the first position.
2_ Press the ISOFIX button at the bottom of the seat
forward and backward with your hand, push the ISOFIX
interface on both sides
to the maximum, press the end of the ISOFIX,
and it will not be retracted.
3_ Insert the ISOFIX of the baby car seat into the
corresponding ISOFIX fixed point of the car, and a click
will be heard to show green in the display window.It will
show red in the display window before ISOFIX inserted
correctly.
4: Push the baby car seat to the back of the car seat
to fit them tightly, shake the baby car seat from side to
side to ensure effective fixation, as shown in the figure.
Before installing the ISOFIX, please take out the top
tether kit in the back cover, pull out the pull-up belt
of a certain length, and hang it on the anti-flip board
temporarily.
4. I-size (40-105cm) top tether Installa
tion (backward installation)
1_ Pull the top tether through the center of the car seat
head and attach to the correspondinghook (Take the
headrest out of the car if necessary, as recommended
in the car manufacturer's manual, for easier installation)
EN
43