Be Cool easy Manual De Instrucciones página 24

1_ Pull the top tether through the center of the car seat
EN
headrest and attach it to the corresponding hook (refer
to the node recommended in the car manufacturer's
manual and remove the headrest for easier installation
if necessary).
2_Tighten the top tether until the top tether regulator
shows green, and shake the seat to check whether
the top tether is tightened.If you want to release the
top tether, press the regulator button and pull the top
tether in the opposite direction, then you can relax the
top tether and take out the top tether hook.
8 I-SIZE (76-105cm) Child mounting
method (forward)
1_ Press and hold the central regulator button while
pulling the shoulder strap outwards to relax the shoul-
der strap..
2_ Press the red button to open the buckle
3_ Pull out the shoulder straps and place them on both
sides of the seat.
46
4_ When i-size (40-105cm) is used by children, please
refer to the above picture description for the shoulder
strap.
5_ Pull and adjust the safety belt outward to make
the shoulder belt effectively restrain the children, and
reserve a certain space to prevent the child seat belt
from pressing the children too much. The adult palm
can be inserted just between the safety belt and the
children's chest. It is better not to be loose or tight, and
ensure that the pelvis area can be well restrained when
the belt is worn.Note: The bottom of both sides of the
shoulder shield should be close to the same level and
pulled down to the bottom.
6_ How to use the buckle: put the buckle insert around
and together, and then insert the buckle slot at the
same time. The sound of clicking indicates that the
buckle has been stuck.Then pull up the clip insert to
check whether the clip is properly locked.To unfasten
the clasp, press the red button and the clasp insert will
pop out automatically.
7_ Pull the headrest handle upward to adjust the height
of the headrest. Adjust the height to the right position
according to the different heights of the child.
8_ After the baby is seated, adjust the head to the right
position (note: the lowest part of the head is 1-2 fingers
away from the shoulder is the best).
9 FIVE-POINT SAFETY BELT
CONCEALMENT
1_ Shoulder guard separation: open the shoulder guard,
separate the connector from the shoulder belt, pull out
the shoulder guard, and keep the shoulder guard for
future use.
2_ Open the buckle as shown in the picture, adjust the
safety belt to the longest, open the cloth cover, put the
buckle insert into the grooves on both sides, and then
put the buckle insert into the groove under the cloth
cover and seat cushion.
3_ After the five-point safety belt is hidden, it depends
on whether the head can be adjusted.Finally, please
put away the important parts after the demolition.The
effect diagram of the back and front of the finished seat
is shown above.
10. 100-150cm:
1. ISOFIX attachments+adult safety-belt
2. Adult safety-belt
Attention
A_ his ECRS seat is installed forward and suitable for
children with height of 100-150cm. Only one seat
can be adjusted as the second position.
B_ Hide the five-point safety belt and pad before
using the ECRS seat.
C_ Suitable for models with ISOFIX systems which
pass ECE R14 and with three-point seat belt/seat
belt with a retractor which pass ECE R16.
D_ Don t use force-bearing points without marking.
E_ When using forward, please remove the backward
protection system.It is not suitable for cars with
only two point seat belts.
ISOFIX attachments+adult safe-belt
1_ Please rotate the seat to the forward state first and
EN
47