Publicidad
Idiomas disponibles
Idiomas disponibles
Before performing cleaning, adjusting, repairing and
maintenance tasks, always unplug the power cord.
Replace worn out or damaged parts immediately, so that
the power tool is always in a safe operating condition.
Cleaning:
The appliance must be completely cleaned after each use.
Do not use aggressive cleaning products. These products
may damage plastics and metals, compromising the safe
operation of the power tool.
Maintenance:
Only maintenance works described in this instruction
manual may be carried out, all other works must be
performed by an official distributor.
If components or safety devices are removed for
maintenance purposes, they must be repositioned correctly
and immediately.
Maintenance of double insulated tools requires extreme
care and knowledge of the whole system and should only
be carried out by a qualified technician. Replacement of
components of a double insulated power tool should be
carried out with the same parts as the originals.
Use only VITO-approved accessories for this appliance or
technically identical parts. Failure to do so may result in
personal injuries or damages to the lawnmower. If in doubt,
if you lack knowledge or resources, you should contact an
official distributor.
Your lawnmower should only be serviced by the
manufacturer's internal service personnel, or other
qualified personnel, replacing any necessary parts with
original parts.
1. Place the appliance on a flat surface and fit the wheels
(13) onto the shafts;
2. Place the washer;
3. Insert the split pin into the shaft's hole and bend it so
that it cannot come out;
4. Fit the wheel cap (12) by pressing it.
To fit it to the appliance, lift the rear discharge cover (9) and
fit the grass box to the top mounting brackets.
1. Secure the handlebar support bar (2), by tightening it
with the bolts;
2. Attach the extension cord holder to the handlebar (7);
3. Align the support bars holes with the handlebar holes
(7);
4. Insert the handlebar fixing bolts (3) from the inside to
the outside;
5. Insert the washer and then the handlebar clamping
knob (8);
6. Secure the power switch cable to the support bar using
cable ties.
Publicidad
