tau K580M Guía Para La Instalación página 13

CONTROL PANEL FOR ONE 230V AC MOTOR
• MICROPROCESSOR-CONTROLLED LOGIC
• INPUT STATUS LED'S
• LINE INPUT FUSE
• BUILT-IN FLASHING LIGHT CIRCUIT
• 433.92 MHz 2 CHANNEL BUILT-IN RADIO RECEIVER (CH)
• OPERATING TIME FIXED AT 120 sec.
• AUTOMATIC DETECTION OF THE FEEDING FREQUENCY (50 or 60 Hz)
• MOTOR TORQUE CONTROL AND OBSTACLE DETECTION BY MEANS OF ENCODER
• ADJUSTABLE DECELERATION
ATTENTION:
- do not use single cables (with one single wire), ex. telephone cables, in order to avoid
breakdowns of the line and false contacts;
- do not re-use old pre-existing cables.
TESTING
When you have completed the connection:
• All the green LEDs must be on (each of them corresponds to a Normally Closed input). The go off
only when the controls to which they are associated are operated.
• The red opening command LEDs must all be unlit (each corresponding to a Normally Open input)
and illuminate only when the commands they are associated with are given; red LED DL8 must
be illuminated steadily.
TECHNICAL CHARACTERISTICS
Power input to board
Nominal power
Fast acting fuse for protection of input power supply 230V AC (F1 - 5x20)
Input voltage of motor circuits
Input voltage of auxiliary circuits
Fast acting fuse for protection of auxiliary circuits 24V AC (F2 - 5x20)
Working temperature
Box protected to
DIAGNOSTICS LED
DL1 (PHOTO)
DL2 (SENSITIVE EDGE)
DL3 (CLOSE LIMIT SWITCH)
DL4 (OPEN LIMIT SWITCH)
DL5 (STOP)
DL6 (PEDESTRIAN)
DL7 (OPEN/CLOSE)
DL8 (RADIO CONTROLS)
TERMINAL BOARD CONNECTIONS
Terminals Function
POWER
1 - 2 - 3
SUPPLY
FLASHING
4 - 5
LIGHT
6 - 9 OPEN/CLOSE
7 - 9 PEDESTRIAN
PHOTOCELL green LED signal
SENSITIVE EDGE green LED signal
CLOSE LIMIT SWITCH green LED signal
OPEN LIMIT SWITCH green LED signal
STOP button green LED signal
PEDESTRIAN button red LED signal
OPEN/CLOSE button red LED signal
RADIO CONTROLS programming red led
Description
POWER input 230 Vac 50Hz (115 Vac 60 Hz).
1= NEUTRAL 2= EARTH 3= PHASE;
FLASHING LIGHT output 230 Vac 50 W max. The signal is already
modulated for direct use. The flashing frequency during closing is
double. 4= 230 Vac, 5= 0 Vac;
OPEN/CLOSE pushbutton input (Normally Open contact);
PEDESTRIAN pushbutton input (Normally Open contact);
K580M
230V AC - 50 Hz
400 W
F 3,15 A
230V AC
24V AC
F 500 mA
-20°C ÷ +55°C
IP 44
13