HAYGAIN HG ONE Manual Del Usuario página 15

Using Your Haygain
Filling the steam generator with water
Before you can start steaming forage, you need to fill the steam generator with water.
To fill the steam generator with water
1. To ensure the steam generator is empty, hold it by the handle and tilt it. Empty the
water through the filler spout into a drain or container.
2. Place the funnel in the filler spout.
3. Remove the funnel from the steam generator, then screw on the safety cap and
tighten it by hand.
Loading Forage
Please note not all hay bales are created equally. Hay capacities are estimated.
HG ONE: Can hold 8 kg of loose
forage, or one hay net.
15
Hay Steamer
®
Warning: Do not open the safety cap on the steam generator when the
steam generator is hot. Ensure the steam generator has cooled down.
Unscrew the safety cap on the steam generator.
Carefully pour up to 8 litres/1.7 gallons of clean tap water into the steam
generator.
If you are only steaming one bale, we recommend you use 6 litres of
clean tap water.
Carefully pour up to 3.5 litres/0.76 gallons of clean tap water into the
steam generator. The wooden dipstick can be used to check the water
level.
Take care not to overfill the steam generator with water. Never add
anti-freeze or other additives to the water. Do not pour cold water into
an empty boiler when hot as this will damage the element.
l
HG 600: Can hold just over half a bale
of forage, several hay nets, or
loose forage up to 15kg.
© Haygain