VONROC WC502AC Traducción Del Manual Original página 8

EN
sion. NOTE The temperature „130 °C" can be
replaced by the temperature „265 °F".
g) Follow all charging instructions and do not
charge the battery pack or tool outside the
temperature range specified in the instructi­
ons. Charging improperly or at temperatures
outside the specified range may damage the
battery and increase the risk of fire.
6) Service
a) Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the
power tool is maintained.
b) Never service damaged battery packs. Service
of battery packs should only be performed by the
manufacturer or authorized service providers.
ADDITIONAL SAFETY WARNINGS FOR
WALL CHASER
• Warning of laser radiation. Laser class 2, P
max.: <1 mW, λ: 650 nm, EN 60825-1:2014.
Do not look directly into the laser beam or the
opening from which it emerges. Never point
the laser beam at people, animals or reflective
surfaces. Even brief eye contact can lead to eye
damage. Examining the laser output aperture
by use of optical instruments (e.g. magnifying
glass, magnifiers and the like) entails the risk of
eye damage. When working with a laser of class
2, observe the national regulations on wearing
eye protection.
• Do not work materials containing asbestos.
Asbestos is considered carcinogenic.
• Wear safety goggles, hearing protection and
if necessary other protective means, such as
safety gloves, safety shoes, etc.
• Before use, remove all nails and other metal
objects from the wall.
• Be aware of hidden pipes and wiring when
cutting slots into walls.
• Always hold the machine with two hands.
• Do not use the machine without the guard.
• Inspect the cutting discs before each use.
Do not use cutting discs which are bent, crac-
ked, or otherwise damaged.
• Make sure that the cutting discs are properly
mounted.
• Make sure that the cutting discs rotate in the
correct direction.
• Do not use the machine with the cutting discs
8
facing upwards or to the side.
• Only use cutting discs that are suitable for use
with the machine.
• Only use cutting discs with the correct dimensions.
• Do not use other accessories than cutting discs.
• Do not use the machine when a maximum slot
depth is required that exceeds the maximum
slot depth of the cutting discs.
• Make sure that your hands do not touch the
rotating parts.
• Always work in the correct working direction
(see indication on the base).
• Let the machine run at no load in a safe area
after mounting the cutting discs. If the machine
vibrates strongly, immediately switch off the
machine, remove the mains plug from the
mains, and try to solve the problem.
• Beware that the cutting discs continue to rotate
for a short period after switching off the machine.
Do not attempt to bring the cutting discs to
a standstill yourself.
• Never put the machine down on a table or
a workbench before it has been switched off.
Kickback
Kickback is the upward and backward movement of
the cutting discs when the cutting discs unexpec-
tedly touch an object. Securely hold the machine
with both hands during use. Keep your attention
focused on the operation.
Kickback is usually caused by:
- unintentionally touching hard objects or materi-
als with the rotating cutting discs;
- blunt cutting discs;
- cutting discs that are not properly mounted;
- cutting into a previous cut;
- a lack of attention to the operation;
- an instable stance.
Electrical safety
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate.
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm . If you use an extension
2
cable reel, always fully unroll the cable.
WWW.VONROC.COM