Publicidad
Idiomas disponibles
Idiomas disponibles
1 - Emergency shutdown
2 - OTP protection
3 - Engine
4 - Movement switch
INSTALLATION CONDITIONS
CAUTION: Before proceeding to assemblying the device, make sure that all
elements are complete and undamaged! In case of discrepancies, contact the
supplier immediately!
Place the unit in such a way that the mains plug can be reached at any time. Ensure
that the power supply to the unit corresponds to that specified on the identification
plate!
The load-bearing capacity of the structure (base and supporting profile) used for the
installation of the device must withstand a load several times greater than the
maximum allowable working load. Responsibility for following the strength
parameters, quality of the supporting structure and the installation of the device on
the supporting structure lies with the user.
ASSEMBLY OF THE UNIT
a) The device should be installed by a qualified person.
b) The design of the device is adapted to installation on a beam with a rectangular
cross-section (A).
c)
The dimensions of the beam must correspond to the dimensions of the
mounting elements of the device.
d) After mounting the device onto the carrying structure, check the correctness of
mounting the assembly screws. Tighten is loose.
e) Remove the securing tape from the cable drum.
5 - Capacitor
6 - Control cable
7 - "Down" limit switch
8 - "Up" limit switch
Publicidad
