Ryobi RY20WP18BTL Manual Del Operador página 8

WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Keep water discharge pointed away from all electrical
devices to reduce the risk of electrocution or electric
shock.
WARNING:
Make sure all hose connections are secure before using
the transfer pump. Spilled water and leaks can result in
a slippery surface and create a slip and fall hazard.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
WARNING:
Always remove battery pack or unplug power cord from
your product when you are assembling parts, making
adjustments, cleaning, or when not in use. Removing
battery pack or unplugging power cord will prevent acci-
dental starting that could cause serious personal injury.
APPLICATIONS
You may use this tool for the purpose listed below:
 Drain or remove water from flooded areas, clogged sinks,
water basins, water heaters, swimming pools, etc.
 Irrigation
OPERATION
INSTALLING/REMOVING BATTERY PACK
See Figures 4 - 5.
WARNING:
Always remove battery pack from your tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
To install:
Open the battery cover by releasing the latch and opening

the cover.
Place the battery pack in the battery compartment and

insert it into the product as shown.
WARNING:
Make sure the latches on each side of the battery pack
snap in place and the battery pack is fully seated and
secure in the battery port before beginning operation.
Failure to securely seat the battery pack could cause the
battery pack to fall out, resulting in serious personal injury.
NOTICE:
When placing battery pack in the tool, be sure raised rib
on battery pack aligns with the bottom of the tool and
latches into place properly. Improper installation of the
battery pack can cause damage to internal components.
Close the battery cover and fasten the latch to secure

the cover.
To remove:
Unlock and open the battery cover.

Depress the latches and pull to release and remove the

battery pack.
Close and secure the battery cover.

WARNING:
Battery tools are always in operating condition. Therefore,
switch should always be in the OFF position when not in
use. Remove battery pack when transporting or carrying
the unit to avoid accidental starting, which could result
in serious injury.
For complete charging instructions, refer to the Operator's
Manuals for your RYOBI battery pack and charger models.
6 — English