Publicidad
Idiomas disponibles
Idiomas disponibles
Replacing the inner lens - to remove the inner lens, pull the top corner. Fix
•
the new protective lens only after removing the protective film. Insert the
edge of the lens under the abutment of the side and slightly bend the lens
in the middle part and place its opposite side to the previous one under
the abutment on the other side to make it pop into place:
3.4.1 Troubleshooting
Problem
The dimming filter does
not work or flickers
The
dimming
responds too slowly.
Possible cause
One of the protective
lenses
damaged.
Dirty (obscured) light
sensors (x4).
The welding current is
too low.
filter
The
temperature is too low.
is
dirty
or
ambient
Solution
Clean or replace the lens
in question.
Clean the surface of the
sensors in the filter
housing.
Increase the sensitivity
of the dimming filter.
Use the product only in
the temperature range:
-5 - +23
o
C.
Publicidad
