STAMOS X-BASIC Manual De Instrucciones página 26

•
•
3.3.5 Headband adjustment
Proper adjustment of the headbands affects the ergonomics and
safety of the operator.
a) Adjust the band to the appropriate depth of the product on the
b) Adjusting the distance of the lens from the face. To adjust, set
c)
d) Segment plate feed with another positioning hole to adjust the
3.4.
Cleaning and maintenance
a) Use only non-corrosive cleaning agents for cleaning surfaces.
b) Store the unit in a dry and cool place protected from moisture and direct
sunlight.
The minimum response delay time in the range of approx. 0.1-
0.2 s (depending on the model) is intended for spot welding.
The maximum response delay time of 0.85-1.0 s (depending on
the model) is intended for welding with high current or when
intense visible light is produced.
head to ensure balance and stability.
the set screw in another hole by moving it forward or backward
and tightening it again - both sides should be identically aligned
for proper visibility of the operator.
The knob for adjusting the diameter of the band relative to the
circumference of the head.
window angle for a clear view. The numbers on the adjustment
sliders indicate the corresponding position, so both sides can be
equally adjusted.