Shark D-SKWAL 3 Manual Del Usuario página 22

ASSEMBLING THE INTERIOR
(CONTINUED)
5 - Reposition each of the two comfort
liner clips to face their slot on one side
and then the other and press them into
place.
6 - Check that the comfort liner is
properly repositioned and is stretched
from the front to the back of the helmet.
WARNING! The positioning of
the interior is critical to how
the helmet fits your head. If you have
any doubts about how the interior was
removed or reinstalled, do not use your
helmet. Contact your retailer for assis-
tance and advice. Never use a helmet
without any one of its interior parts, as
it will not protect you in the event of
an accident.
22
WARNING! The cap and the
interior comfort liner are made
to fit perfectly on your head. In the
event of an accident, a helmet that does
not fit you may come off, leaving your
head unprotected and causing serious or
even life-threatening injuries.
POSITIONING THE CHEEK PADS
3
1 - Thread the corresponding chinstrap
end through each of the cheek pads. Use
the red snap fasteners to guide you in
identifying in which direction the cheek
pads must be reinserted.
4
2 - Clip each of the three clips per cheek
pad into their slots, starting with the rear
clip, then the middle clip and finally the
front clip.
3 3
2 2
1 1
1
2