Publicidad
Instructions for Use
4UHV Ion Pump Controller Shutdown
To switch off the HV channels:
Hold down the HV ON/OFF (2) button while pressing the HV-x (3, 4, 5, 6) button
where x is the number of the channel to be switched on/off.
For further details on using the controller and for a description of the information
appearing on the display, refer to the section "Technical Information".
Emergency Stop
In situations of emergency, to switch off the unit and all the high voltage
WARNING
channels, turn off the main power switch (1) situated on the front panel.
When the main switch is turned off, the HV unit is switched off.
Maintenance
The 4UHV Ion Pump Controller does not require any maintenance. Any form of
servicing on the unit must be performed by authorized personnel.
If servicing is needed, contact Agilent Technical Support or subscribe to the "Agilent
Advanced Exchange Service" where the faulty controller is replaced by a refurbished
one.
If the controller needs to be scraped, proceed to do so in compliance with the
specific national norms.
WARNING
Before carrying out any work on the controller, disconnect it from
the supply.
Agilent 4UHV Ion Pump Controller User Manual
161
Publicidad
