Publicidad
Idiomas disponibles
Idiomas disponibles
Page 2
ENGLISH
Section 1.
Safety Information ................................ 3
Section 2.
Product Description and Model
Numbers ................................................ 4
Section 3.
Installing Jandy Light Fixture
During New Construction .................... 5
3.1
Preparing the Light Fixture for Installation .......... 5
3.2
Installing the Light Fixture ................................. 6
Section 4.
Replacing Jandy Light Fixture
in an Existing Pool or Spa ................... 6
4.1
Preparing the Light Fixture for Replacement ...... 6
4.2
Replacing the Light Fixture ................................ 7
Section 5.
Wiring Options for Controlling
Jandy WaterColors LED Lights ........... 8
5.1
Wiring to an AquaLink
5.2
Wiring to a Time Clock ....................................... 8
5.3
Wiring to a Switch ............................................... 8
Section 6.
Jandy WaterColors RGBW LED
Light Operating Instructions ............... 8
6.1
To Operate the Light and Change Colors ........... 8
6.2
To Reset to the Beginning of the
Color Sequence ................................................ 10
FCC Regulatory Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance may void the
user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Table of Contents
RS Control System ....... 8
®
Jandy
WaterColors RGBW LED Lights | Installation & Operation Manual
®
Section 7.
Replacing LED Board and
Driver (PCB) ........................................ 10
7.1
Pool Clamp Removal. ....................................... 10
7.2
12V Small Light Driver (PCB) Replacement ..... 10
7.3
120V Small LED Board Replacement ...............11
7.4
120V Small Light Driver (PCB) Replacement ....11
7.5
Large Light Driver (PCB) Replacement
(120V and 12V) .................................................11
7.6
Reassemble the Fixture. ..................................11
7.7
Reinstall the Jandy Light Into Niche Fixture. .... 13
Section 8.
Twelve (12) Volt Installation ............... 13
Section 9.
Exploded View and
Replacement Parts ............................. 14
9.1
Jandy Large WaterColors RGBW LED Light .... 14
9.2
Jandy Small WaterColors RGBW LED Light .... 15
Publicidad
