Husqvarna Xcite Z350 Manual De Usuario página 29

Warning messages on the display
A warning indicator flashes and the symbol for the
type of warning shows. If the warning indicator
Symbol Name
Warning indicator
Slope indicator
Headlights
Battery level indicator
PTO (Power Take-Off) indi-
cator
Parking brake indicator
Engine indicator
Transportation
• Do not tow the product.
• The product is heavy and can cause crush
injuries. Be careful when you load it onto or off
a vehicle or trailer.
• Load the product in reverse on approved ramps
of a maximum operation angle of 10°. Do not lift
the product.
• Use an approved trailer for transportation of the
product.
• Make sure that you have knowledge of local
road traffic regulations before transportation of
the product in a trailer or on roads.
• Lock the product with approved devices, such
as straps. Use tie-down points on the product
or applicable areas of the frame. The parking
brake is not sufficient to lock the product during
transportation.
1922 - 006 - 13.12.2022
Transportation, storage and disposal
shows together with an error number, speak to your
Husqvarna servicing dealer.
Cause
Safety warning. The other symbol shows the warning type.
You operate the product in a slope >10°. Refer to
instructions for operation on slopes on page 10 .
The headlights are on.
The battery has low voltage. Refer to
on page 21 .
The drive of the blades is engaged.
The parking brake is engaged.
There is an engine problem.
Storage
Prepare the product for storage at the end of the
season, and before more than 30 days of storage. If
you keep fuel in the fuel tank for 30 days or more,
tacky particles can cause blockage in the carburetor.
This has a negative effect on the engine function.
To prevent tacky particles during storage, add a
stabilizer. If alkylate gasoline is used, stabilizer is
not necessary. If you use standard gasoline, do
not change to alkylate gasoline. This can cause
sensitive rubber parts to become hard. Add stabilizer
to the fuel in the tank or in the container used for
storage. Always use the mixing ratios given by the
manufacturer. Add the stabilizer and run the engine
for a minimum of 10 minutes, until the fuel flows into
the carburetor.
Safety
To charge the battery
29