Publicidad
Idiomas disponibles
Idiomas disponibles
2. Do the daily maintenance. Refer to
schedule on page 16 .
3. Make sure that the work area is clean and bright.
4. Use personal protective equipment. Refer to
Personal protective equipment on page 7 .
5. Make sure that the product is installed correctly.
6. Make sure that the frequency and voltage shown on
the type plate agrees with the power supply voltage.
This is also applicable for the extension cables.
7. Make sure that the power plug is connected
correctly.
To attach the dust extraction hose
You can use the product with a dust extraction hose with
diameter 150 mm/6 in or diameter 127 mm/5 in. Use an
antistatic dust extraction hose.
1. Connect the dust extraction hose with hose clamps
and industrial tape.
2. If you use a dust extraction hose with diameter 127
mm/5 in, install the dust extraction hose adapter. Do
the steps that follow:
a) Put the dust extraction hose adapter (A) on the
air intake.
C
A
b) Put the clamps in the slots on the adapter (B).
c) Tighten the screw on the clamps (C).
To engage and disengage the parking brake
The parking brake must be engaged before you start the
product.
10
Maintenance
1. Push the lock lever down to engage the parking
2. To disengage the parking brake, push the lock lever
Vacuum gauge
The vacuum gauge shows the condition of the primary
filters. If the value on the vacuum gauge is 7.8 inH
cmH
filters. Refer to
18 . If the value on the vacuum gauge is 5.9 inH
cmH
is necessary to replace the primary filters. Refer to
replace the primary filters on page 19 .
B
Pressure tank gauge
The pressure tank gauge shows the pressure in the
pressure tank. The air in the pressure tank cleans the
brake.
up.
O or higher, it is necessary to clean the primary
2
To clean the primary filters on page
O or higher after you clean the primary filters, it
2
O/20
2
O/15
2
To
2061 - 001 - 13.02.2023
Publicidad
