hillvert HT-FORBES-600 Manual De Instrucciones página 39

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 127
Turn the ignition switch on the engine to the "ON" position so that the
engine can be started.
Grasp the lever of the starter tug and pull in a steady motion until you feel
resistance on the lever, then with a quick movement pull to the end, all
the while holding the handle in your hand allowing it to return to the
starting position in a controlled manner. Sometimes in freezing
conditions, it may be necessary to pull the tug handle several times before
the engine starts - this is normal.
After starting the engine, make sure that the chain does not turn, and if
the engine is cold, let it run for approx. 3-4 minutes to obtain the operating
temperature. During this time, gradually move the manual choke lever in
the off direction ("RUN" or "OPEN" - depending on the type of engine).
NOTE: starting a warm engine does not require manual choke - its lever should
be in the open position ("RUN" or "OPEN" - depending on the type of engine).
3.3.2 Stopping
Set the slowest engine speed with the throttle lever (move it towards the
turtle icon) and let the engine run at low speed for 1-2 minutes to cool it
down a bit.
Switch off the ignition by setting its switch to the "OFF" position or move
the switch-off lever on the steering wheel.
IMPORTANT: never use the choke lever to stop the engine by throttling it!
If the machine will not be used further, close the fuel valve - set its lever
to the closed position.
3.3.3 Work
IMPORTANT: Stand only behind the machine and at the steering wheel
when digging.
Turn the digging depth adjustment knob (a) counterclockwise to raise the
digging unit (b) and then lock the feed lock lever (c) so that the machine
can be driven by the steering wheel (d) only forwards:

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ht-forbes-450

Tabla de contenido