Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
The end pieces are also removable allowing you to clear
u
the brushes from any hair or other debris that may have
accumulated.
Wash the beater bar with warm soapy water.
u
Removing exhaust filter (Fig. O)
The exhaust filter (17) can be cleaned or replaced by the
customer, replacement filters are available from your
BLACK+DECKER Service Centre. It's been designed to be in
an obvious place and easily removable.
Press the exhaust filter release button (17a).
u
Withdraw the exhaust filter (17) as shown in figure N.
u
The filter can be tapped free of debris or rinsed with water.
u
Allow 24 hours to dry. Do not use soap.
Replace cleaned or new filter.
u
Storage
The unit can be safety stored using the charging wall dock as
shown in figure C.
Maintenance
Your BLACK+DECKER cordless appliance has been designed
to operate over a long period of time with a minimum of main-
tenance. Continuous satisfactory operation depends upon
proper tool care and regular cleaning.
Warning! Before performing any maintenance on cordless
appliances:
Run the battery down completely if it is integral and then
u
switch off.
Unplug the charger before cleaning it. Your charger does
u
not require any maintenance apart from regular cleaning.
Regularly clean the ventilation slots in your appliance/
u
charger using a soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth. Do
u
not use any abrasive or solvent-based cleaner.
Replacing the filters
The filters should be replaced every 6 to 9 months and when-
ever worn or damaged. Replacement filters are available from
your BLACK+DECKER SERVICE CENTER.
Visit www/2hepu.com to locate a service center
Remove the old filters as described above.
u
Fit the new filters as described above.
u
Troubleshooting
Problem
Possible cause
Unit will not start.
Battery pack not
charged.
Blockage.
12
(Original instructions)
Possible solution
Check charging
requirements.
Check floorhead tube.
Check extension tube.
Check between extension tube
and bowl.
Battery pack will
Charger not
not charge.
plugged in.
Surrounding air
temperature too
hot or too cold.
Rotary brush
Obstruction.
stops working.
Rug or thick/loose
pile carpet
Vacuum
Clogged dust
performance is
bowl.
poor.
Filters are dirty.
Rotary brush
Protecting the environment
Z
Separate collection. Products and batteries
marked with this symbol must not be disposed of
with normal household waste.
Products and batteries contain materials that can be recov-
ered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com
Technical Data
Voltage
Watt Hours
Approx Charge Times
Weight
Plug charger into a working
outlet. Refer to Important
Charging Notes for
more details.
Move charger and battery
pack to an area above
4 °C or below +40 °C.
The unit is equipped with
a rotary brush overload
protection feature. (See
Removing and Cleaning the
Rotarty Brushes section.)
The unit is equipped with
a rotary brush overload
feature. Rugs and carpet with
very thick and/or loose pile, can
cause the overload feature to
activate and the rotary brush will
stop rotating. Try cleaning on the
hard floor speed setting (2). If
the problem persists, the surface
is not suitable for cleaning with
rotary brush bars.
Empty the dust bowl. (See
Cleaning and Emptying the
vacuum section.)
Clean the filters. (See
Cleaning and Emptying the
vacuum section.)
Clean the rotary brush. (See
Removing and Cleaning the
Rotarty Brushes section.)
BHFEA640W, BHFEA640WP
21.6v
86.4Wh
4hrs
3.56kg
Publicidad
