Bulldog DC Serie Manual De Instrucciones página 9

Figure 6 - Roller Fairlead
Use a Roller fairlead with wire rope.rope.
Roller
Fairlead
1.6 Wiring
1.6.1 Install the Wiring
WARNING
BEFORE installing the winch, make sure all electrical parts are corrosion free.
ALWAYS place the supplied terminal boots on wires and terminals as directed by the installation
instructions.
NEVER lean over battery while making connections.
NEVER route electrical cables over battery terminals.
ALWAYS consult Electrical Connections section for proper wiring details.
Run the charging system during winching operations to keep battery charged.
NEVER route electrical cables across sharp edges.
NEVER route electrical cables near parts that get hot.
NEVER route electrical cables through or near moving parts.
AVOID pinch and wear/abrasion points when installing all electrical cables.
ALWAYS insulate and protect all exposed wiring and electrical terminals.
1.6.2 Battery Recommendations & Lead Size
A fully charged battery and good connections are essential for the proper operation of your winch.
The minimum requirement for the battery is 650 cold cranking amps. The battery lead shall be 2 gauge
with 72" in length at most, otherwise a considerable voltage drop will occur.
1.6.3 Battery Cable Routing
Route battery connection cables in areas that will not cause them to chafe or cut through the insu-
lation causing a potential short circuit. The winch power wire must be routed to the battery. A direct
battery connection of the power (red) and ground (black) cables is required.
CEQUENT
Installation Instructions
PERFORMANCE PRODUCTS, INC. •
™
Figure 7 - Hawse Fairlead
Use a Hawse fairlead when using synthetic rope.
Hawse
Fairlead
F4024-00 REV C (7026) 7/16
9