Aritech VV700 Serie Manual De Instalación página 3

4
EN: Installation Sheet
General characteristics of the VV700
Figure 1
(1) Cover
(2) Cover screw
(3) Steel clip
(4) Plug-in board
(5) Base plate
(6) Mounting holes
(7) Cable clamp
(8) Screw terminal
(9) Connector for plug-in
board
(10) Test transmitter
connector
(11) Communication port
(12) Anti-tamper micro
switch
P/N 466-5603 (ML) • REV A • ISS 20APR21
(13) Area for mounting the VT705P
test transmitter
(14) Mounting plate
(15) Fixing bolt
(16) Expander bolt
(17) Test transmitter VT705P
A Holes for VV700
B Holes for Securitas SSD70
C Holes for Cerberus / Alarmcom
seismic detector
D Holes for expansion plug or
recess mounting box
E Holes for Securitas 2000
F Template and mounting holes for
test transmitter VT705P
G Holes for accessories
Using the mounting plate VM600P as a
template
See Figure 1, item 14.
Setting up the detector
See Figure 3.
The VV700 seismic detector must have a plug-in board
(item 1) connected to the detector. Connect the plug-in board
to the detector header (item 2).
Note: Available plug-in boards: Form A relay board = VVI760.
Form C relay board = VVI770.
Use the configuration cable VVI740 (item 4) to enable the
detector and your computer to communicate. Wire the five-pole
connector on the VVI740 to the communication port of the
detector (item 3) and the nine-pole connector to the serial port
of the computer (item 5).
3 / 20