GreenWorks RSG401 Manual Del Operador página 8

EN
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the tool and wait until the motor stops before
you install or remove the battery pack.
• Read and understand the instructions in the
battery and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery
compartment until the battery pack locks into
place.
3. When you hear a click, the battery pack is
installed.
7.6 REMOVE THE BATTERY PACK
1. Push and hold the battery release button.
2. Remove the battery pack from the tool.
8 OPERATION
Always wear eye protection.
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
8.1 START THE TOOL
2
1. Push the lock out switch (1) to the right side to
unlock the trigger.
2. Press the trigger (2).
Variable speed
To change the speed, increase or decrease the
pressure on the trigger. The further the trigger is
pulled, the greater the speed.
8.2 STOP THE TOOL
1. Release the trigger.
WARNING
WARNING
WARNING
1
English
The lock out switch must be in the locked position
when the tool is not in use or is being transported.
8.3 OPERATE THE TOOL
1. Clamp the workpiece.
2. Mark the line of cut clearly.
3. Hold the tool firmly and switch it on.
4. Allow the motor to reach full speed.
5. Place the shoe against the workpiece.
6. Start the cutting work.
Make sure that the blade is not contacting the
workpiece until the motor reaches full speed.
Flush cutting
1. The compact design of the tool permits close
cutting to floors, corners and other difficult areas.
2. To maximize flush cutting capabilities, insert the
blade shaft into the blade clamp with the teeth of
the blade facing up.
3. Turn the saw upside down so you are as close to
the work surface as possible.
Wood cutting
1. Before cutting any type of wood, be sure the
workpiece is firmly anchored or clamped to
prevent slipping.
2. Place blade and shoe lightly against work to be
cut.
8
WARNING
NOTE