Publicidad
Idiomas disponibles
Idiomas disponibles
Fig. 3
22
18. Cabinet with pre-wired switch
19. "V" band
20. Pulley
21. Wedge
ASSEMBLY INSTRUCTIONS
WARNING: For your own safety do not connect the jointer to the
power source until the jointer is completely assembled and you
have read and fully understand the owner's manual.
ELECTRICAL CABINET AND WIRING
Your jointer cabinet (A) Fig. 4 is shipped with the motor and switch
fully wired and the motor is factory assembled.
ASSEMBLING THE JOINTER TO THE CABINET
1.
The jointer outfeed table should be installed on the same side
of the cabinet as the dust extractor hood (B) Fig. 5.
2. Remove the three screws (C) Fig. 5 and loosen the three screws
(D). Remove the rear panel (E) from the cabinet by lifting the
panel upwards.
3. Align the three holes (F) and (L) Fig. 6 on the top of the cabinet
with the three holes located on the base of the jointer and
attach the jointer to the cabinet with three M 10 Allen screws
(G) Fig. 7, three flat washers (H), three lock washers (J) and
three hex nuts (K).
Fig. 4
6
18
23
20
21
19
A
24
22. Connector for dust extraction system
23. Safety pedal
24. Mounting screws
Fig. 5
E
D
Fig. 6
F
Fig. 7
G
K
C
B
L
H
J
Publicidad
