Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION: The jointer is extremely heavy. It is suggested that lifting
or carrying the jointer or the jointer mechanism be done by at
least two people.
IMPORTANT: The mounting screws for attaching the jointer to the
cabinet through the holes (F) must be installed from the bottom
up to the base of the jointer. The screw for mounting the jointer
to the cabinet through the hole (L) should be installed from the
bottom up to the base of the jointer.
FEED TABLE ADJUSTMENT HANDLE ASSEMBLY
1.
Screw the lock nut (A) Fig. 9 clockwise onto the end of the
adjusting handle (B) Fig. 8 as far in as it will go.
2. Screw the handle (B) Fig. 8 into the block (C) Fig. 9 located
under the feed table (D) Fig. 8. Tighten the lock nut (A) against
the block (C) Fig. 9 as shown.
Fig. 8
Fig. 8
C
B
Fig. 9
C
A
MOTOR PULLEY ASSEMBLY
Assemble the motor sheave (A) Fig. 10, to the motor shaft (B) with
Fig. 10
Fig. 10
A
B
C
the center of the pulley on the outside as shown. Make sure that
the shim (C) is inserted into the shim channel of the motor pulley
and motor shaft. Tighten the set screw (located in the center of
the pulley) against the motor shaft (B).
BELT ASSEMBLY AND PULLEY ALIGNMENT
1.
2. Ensure that the motor pulley (C), is aligned with the cutterhead
3. If adjustment is necessary, the motor pulley (C) Fig. 12 can be
BELT TENSION ADJUSTMENT
Correct belt tension is obtained when there is a deflection of
approximately 1" at the center of the belt by applying light finger
D
pressure. If adjustment is necessary, the motor can be raised or
lowered by loosening the four mounting bolts, two of which are
shown in Fig. 12. (F),
Tighten the motor mounting hardware after belt tension has been
obtained.
NOTE: Make sure the motor pulley is aligned with the cutterhead
pulley. Reassemble the rear panel on the cabinet, which had been
removed in STEP 2 of the "ASSEMBLING THE CANTER TO THE
CABINET" section.
D
Place the belt (A) Fig. 11, inside the grooves of the cutterhead
pulley (B) and motor pulley (C).
pulley (B) Fig. 11, by installing a square (D) on the face of each
pulley as shown in Fig. 12.
moved on or off the motor shaft, or the motor can be moved
by loosening the four mounting screws, two of which are shown
(E) in Fig. 12. After adjustment has been completed, tighten
the four motor mounting screws or the set screw in the center
of the motor pulley, depending on which adjustment you have
made.
Fig. 11
B
A
C
Fig. 12
E
F
B
D
C
7
Publicidad
