Truper MUT-60A Instructivo página 21

4. PANEL DESCRIPTION
1. 3 3/4 digits LCD
2. Range Button
The Digital multimeter defaults to the auto range mode when you
measure the voltage, current and resistance. When the Digital
multimeter is in the auto range mode, "AUTO" is displayed.
To enter and exit the manual range mode:
a. Press " RANGE" button
The Digital multimeter enters the manual range mode and the symbol
"AUTO" turns off.
b. To exit the manual range mode, press and hold down the "RANGE"
button for 2 seconds, the Digital multimeter returns to the auto range
mode and the symbol "AUTO" is displayed.
3. Select Button
When your range on V , mA , A , press this button will switch the
Digital multimeter between DC function and AC function.
When your range on " " range, press this button can select Ohm,
capacitance, diode and the continuity functions.
When your range on "°C / °F" range, press this button to select °C or
°F mode.
4. Relative Button
This Digital multimeter will display relative measurements in all
functions except frequency, Ohm, Diode and Audible Continuity
function.
5. "COM" Jack
Plug-in connector for black (negative) test lead.
6. "10 A" Jack
Plug-in connector for the red test lead for Current (600 mA ~ 10 A)
measurements.
7. "Max/Min" Button
After press the button will display the maximum and minimum values
during the test. The maximum and minimum values are cleared after
the changes the test function,or meter be off.