ALFRA 03250.L Manual De Instrucciones página 22

Fig. 5: Blade in the lower position
• Activate the hydraulic pump and allow the blade to travel down until only a small curvature (1) can be seen
between the blade and the counter cutter.
• Switch off the hydraulic pump and immediately disconnect the hydraulic cou- pling (2) at the cutting unit
so the cutter bar remains at the bottom position.
Fig. 6: Dismantling the retainers
• Loosen the fastening screws
Fig. 7: Loosen the fastening screws
• Now loosen the two M8 screws (5) on the side of the cutter bar.
• Before removing the screws, secure the blade so it cannot fall.
22