Publicidad
Idiomas disponibles
Idiomas disponibles
6. Unit description
The "stationary busbar cutting unit" is equipped with a high-performance singleacting hydraulic cylinder
(9) that achieves a cutting force of approximately 23 tons for a maximum pressure of 700 bar.
Fig. 1: Front and rear view
Key
1) Emergency stop switch
2) Connection socket (7-pin) for the control cable
3) Connection for hydraulic hose
4) Retainer with ball bearings
5) Supporting table
6) Side guide plates
7) Locking lever for retainer
8) Clamping screws for retainer
The cutting force is transferred uniformly via the cutter bar (12) to a replaceable blade (13).
The single-pedal foot-operated safety switch is connected with the cutting unit via the 4-pin socket (10).
In dangerous situations, an additional emergency stop switch (1) can stop the pump immediately and return
the blade to its initial position. The combination of supporting table (5), side guide plates (6) and retainers
(4) ensures a reliable, perpendicular guiding of the busbars. The clamping screws (8) set the height of the
retainers that are fixed at the required position with the locking levers (7).
A line laser integrated in the cutter bar (12) simplifies the exact positioning of the busbar. The four holes (11)
in the frame can be used for the fixed mounting of the unit on a table or workshop trolley.
Fig. 2: Dimensions
18
9) High-pressure hydraulic cylinder
10) Connection socket (4-pin) for the
foot-operated switch
11) Holes for fastening to the work table
12) Cutter bar with integrated line laser
13) Blade
14) ON/OFF switch for laser
Publicidad
