Fimar BAR300P Uso Y Mantenimiento página 18

CHAPTER 4
General safety precautions
It is recommended to comply strictly with the following safety precautions:
- never touch the metal parts of the machine with wet or damp hands;
- do not pull the supply cable or the machine itself to disconnect the plug from the current outlet;
- children or unqualified personnel are not allowed to use the machine without supervision;
- electrical safety of the machine is ensured by its correct connection to an effective earthing as in
accordance with the electrical safety standards in force; it is necessary to check this fundamental
requirement and, if in doubt, ask for a thorough check by professionally qualified personnel. The
manufacturing company cannot be held responsible for possible damages caused by the lack of a plant
earthing;
- in the case of a possible damage to the safety earthing, disconnect the machine in order to prevent its
activation;
- always use fuses complying with safety standards in force, and with the correct value and with the
proper mechanical characteristics;
- do not make use of repaired fuses and avoid causing short circuits between the terminals located on the
fuse holder;
- the user of the machine must not replace its supply cable; in the case the supply cable is damaged or
needs replacing, refer only to the manufacturing company of the machine for its replacement;
- keep the cable away from hot parts;
- always switch off and disconnect the machine from the power supply before beginning any general
cleaning or washing operation;
- clean machine coating, panels and controls using soft and dry cloths, or cloths slightly soaked in mild
alcohol or detergent solution.
Obligations in the case of malfunction and/or potential danger
Operators are obliged to signal any deficiency and/or potentially dangerous situation immediately to a direct
superior.
User obligations
The user must inform the manufacturing company immediately of any safety system defect and/or
malfunction and of any presumed danger encountered. It is strictly forbidden to the user and/or third parties
(excluding duly authorized personnel of the manufacturing company) to make modifications of any kind or
extent to the machine and its functions or to this technical publication. In case of malfunctions or danger
due to the non-observance of the above, the manufacturing company cannot be held responsible for the
consequences. It is advisable to request any modifications directly to the manufacturing company.