SOMFY Roll Up 28 WF RTS II Instrucciones página 10

EN
Observations
The motorised product
stops too soon.
10
Possible causes
The control point is not
compatible or not
programmed. LED doesn't
light when any button of
control point is pressed.
An obstacle hinders the
movement of the
motorised product. The
Red LED lights fixed on.
Drive position is out of the
end limits. Red LED blinks 2
times intermittently and
continually.
The drive is neither set nor
paired. Orange LED lights
fixed on.
The thermal protection has
activated. LED blinks red
continuously.
The end limits are
incorrectly set.
The motorised product has
exceeded recommended
weight limit.
The drive battery is low and
requires charge. Red LED
blinks 5 times when any
button of a paired control
point is pressed.
©
Copyright 2021 SOMFY ACTIVITES SA. All rights reserved.
Roll Up 28 WF RTS II
Solutions
Check the compatibility or
pair the control point as
required referring to
Adding/Deleting control
points [} 18].
Remove the obstacle.
Proceed to section
Readjusting the end limits
[} 11].
Proceed to section
Commissioning [} 7]
Wait for the drive to cool
down (LED will switch off).
Reset the end limits
referring to Readjusting
the end limits [} 11].
Replace motorised
product.
Charge the battery.