Publicidad
4.5
START THE MACHINE
1
CAUTION
Do not operate without the water supply connected.
CAUTION
Before you start the machine:
1.
Turn the water supply on.
2.
Pull the gun trigger to release air pressure.
3.
If a stable stream of water come into view,
release the spray gun trigger.
1.
Connect the machine to the power supply.
2.
Set the power switch to the "ON" ( | ) position.
3.
Turn the water supply on.
4.
Pull the spray gun trigger.
4.6
STOP THE MACHINE
1.
Release the spray gun trigger.
2.
Press down on the ON/OFF switch, once again,
to set the power switch to the "OFF" (O) position.
WARNING
If you do not use the machine：
• Stop the machine.
• Turn the water supply off.
• Disconnect the power cord from the outlet.
• Pull the spray gun trigger to release the remaining
pressure from the machine.
• Engage the trigger safety lock-out on the spray
gun.
English
5
MAINTENANCE
Before maintenance, make sure that you
• Stop the machine.
• Wait until all the moving parts stop.
• Disconnect the plug from the power source.
Do not use strong solvents or detergents on the
plastic housing or components.
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can
cause damage to the plastic, and make the plastic
unserviceable.
Replace the power cord by an approved service
center.
5.1
SPRAY TIP MAINTENANCE
1
11
2
21
If there is too much pump pressure, the spray tip can
become clogged, you can feel a pulsing sensation
while you pull the spray gun trigger.
5.1.1
REMOVE THE SPRAY TIP
1.
Pull back the quick-connect collar on the spray
wand (2).
2.
Remove the spray tip (11) from the spray wand
(2).
5.1.2
CLEAN THE SPRAY TIP
1.
Use a straight paper clip or cleaning tool (21) to
clean the spray tip (11).
2.
Flush and clean the unwanted materials out of
the spray tip (11) with the garden hose (20).
3.
Install the clean spray tip (11) to the spray wand
(2).
11
WARNING
WARNING
WARNING
WARNING
2
EN
Publicidad
