Publicidad
WARNING
• The water supply must come from the water main
• Do not use hot water
• Do not use water from ponds or lakes
WARNING
Do the local regulations when you connect the
garden hose to the water supply. Direct connection
through a receiver tank or backflow preventer is
usually permitted.
CAUTION
Inspect the filter in the water inlet connector before
you connect the garden hose
• If the filter is damaged, do not use the machine
until the filter is replaced.
• If the filter is dirty, clean the filter.
20
4
1.
Uncoil the garden hose (20).
2.
Let the water flow through the garden hose (20)
for 30 seconds.
3.
Turn the water supply off.
4.
Install and tighten the end of the garden hose
(20) to the water inlet (4) connector.
CAUTION
There must be a minimum of 3 m of free hose
between the water inlet and the water supply.
English
4.2
USE THE SPRAY GUN
22
For safe control, keep your hands on the gun at all
times.
• Pull and hold the spray gun trigger (21) to start the
machine.
• Release the spray gun trigger (21) to stop water flow
through the spray tip (11).
4.2.1
UNLOCK THE GUN TRIGGER
• Push the trigger safety lock-out (22) down until it
clicks into the slot.
4.2.2
LOCK THE GUN TRIGGER
• Push the trigger safety lock-out (22) up and into its
original position.
4.3
CHANGE THE SPRAY TIP
1
2
Before you change the spray tip:
1.
Pull the spray gun trigger to release water
pressure.
2.
Engage the trigger safety lock-out on the spray
gun.
3.
Stop the machine.
Do not point the spray wand at your face or others'.
9
21
WARNING
3
Click
WARNING
WARNING
EN
Publicidad
