Publicidad
Idiomas disponibles
Idiomas disponibles
ABICAR 1200 PRO 42V
Setting the oscillation weld parameters (optional)
6.3 Mounting the oscillator on page EN-16
Once the optional oscillator has been connected, the oscillation parameters can be set in the configuration
menu. The following figure shows a graphic representation of the weld oscillation parameters.
Fig. 15
Tab. 6
Parameters
Osc. Amplitude
Osc. Speed
Osc. Delay 1
Osc. Delay 2
Osc. Hold-time lock
Weld oscillation parameters
Osc. Speed
Endpoint
Overview of weld oscillation parameters
Value
0–100%
0–100%
0.0–5.0 s
0.0–5.0 s
YES
NO
Osc. Delay 1
Osc. Amplitude
Weld seam length
Description
Relative oscillation width
Relative oscillation speed.
The higher the speed, the shorter the
oscillation duration.
Time delay in the upper oscillation position
Time delay in the lower oscillation position
YES: Time delay cannot be changed during
welding.
NO: Time delay can be changed during
welding.
6 Putting into operation
Start point
Osc. Delay 2
EN - 23
Publicidad
