Ruby ZEUS 7000 Manual De Instrucciones página 89

• "Preset ON Time" is displayed on the operation panel.
• ON time can be regulated at any time in 0-24 hours.
• Press the "Timer " button again to confi rm, Timer indicator turns on.
• To deactivate the timer function, press"Timer " button until timer indicator turns off.
Timer OFF setting
• When the air-conditioner ON, press "Timer" button and select a desired OFF time through the
temperature and time setting buttons.
• "Preset OFF Time" is displayed on the operation panel.
• OFF time can be regulated at any time in 0-24 hours.
• Press the "Timer " button again to confi rm, Timer indicator turns on.
• To deactivate the timer function, press"Timer " button until timer indicator turns off.
7. SLEEP mode
• While in cooling mode, press the SLEEP key to set the temperature. It increases1ºC after an hour
and at most increases 2ºC after 2 hours.
• While in heating mode, press the SLEEP key to set the temperature. It decreases 1ºC after an hour
and at most decreases 2ºC after 2 hours.
• Press the SLEEP key again can cancel the setting.
8. Water Drainage
Water Full Alarm Function
The inner water tray in the air-conditioner has one water level safety switches, it controls the water level.
When water level reaches an anticipated height, the water full indicator lights up. When the water is full,
please remove the rubber blockage from the drainage hole at the bottom of unit, and drain all water
outside.
Continuous Drainage
• When you plan to leave this unit unused for a long time, please remove the rubber blockage from the
drainage hole at the bottom of unit, and drain all water outside.
• You can use the continuous drainage with a drainage hose connected to the bottom drain hole,
when the unit working at the HEAT mode.
• The continuous drainage is not need to be applied when the unit working at the COOL or DEHUMIDIFY
mode. The unit can evaporate the condensate water automatically by the splash motor. Make sure
the drainage holes are stemmed well.
• If water splash motor is damaged, continuous drainage can be used. To connect the drain hose to
the bottom drain hole (Fig.6), the unit can also work well.
• If splash motor is damaged, intermittent drainage can also be used. Under this condition, when the
water full indicator lights up, please connect a drain hose to the bottom drainage hole, then all the
water in the water tank will be drained outside. The unit can also work well.
90