LINDR CWP 100 Green Line new Instrucciones De Uso página 21

13.2 Speed Fitting Removal:
Hold the grey ring tight against the body of the speed fitting and pull out the hose.
WARNING: If you do not hold the grey ring but pull at the hose, the speed fitting will cut
even deeper into the hose.
WARNING: Hoses must not be pressurised during removal.
14. TEMPERATURE AND ADJUSTMENT
The temperature of the cooled beverage is controlled by a mechanical thermostat in
temperature range of 2 °C to 8 °C. The thermostat has a numerical scale of 1-7.
15. TAP INSTALLATION
1. Turn the compensator lever (1.), so that it points down (see figure). The compensator lever on the
tap is used to adjust the flow rate.
2. Fit the tap perpendicularly onto the spline.
3. Secure with a flare nut and turn left. (loosen to the right).
4. Tighten with the enclosed wrench.
16. CLEANING THE CONDENSER
1. Remove the four screws holding the lid.
2. Remove the lid.
3. Remove the fan.
4. Clean the condenser with compressed air.
17. KEG COUPLER ASSEMBLY
17.1 Outlet for Keg Pressurisation:
Variant of connection with the use of a bushing; the hose is fitted onto the bushing and affixed
with a clip.
WARNING: Before you screw the speed fitting onto the 5/8" thread, make sure the keg
coupler (air inlet for delivery medium) has a lip valve (check valve 17.A) fitted on it.
17.2 Outlet for Beverage:
Screw an F 5/8" x 3/8" (9,5 mm) speed fitting onto the keg coupler.
(see Fig. 14.)
:
(see Fig. 15.)
(see Fig. 16.)
:
(see Fig. 17.)
:
:
EN
21