Removing And Fitting The Appliance Door; Removing The Appliance Door; Fitting The Appliance Door - Siemens VB558C0S0 Instrucciones De Uso

Removing and fitting the appliance door

If the oven is very heavily soiled, the oven door can be
removed for easier cleaning. Normally, however, this is
not necessary.

Removing the appliance door

Open the oven door fully.
1.
Lock the two hinges on the left and right using the
2.
locking pin (a).
The locking pins must be fully inserted into the
Note:
holes in the hinges.
Take hold of the sides of the oven door with both
3.
hands and close the oven door by approx. 30° (b).
Lift the oven door slightly and pull it out.
4.
Do not close the oven door fully,otherwise the
Note:
hinges could become bent and the enamel could be
damaged.

Fitting the appliance door

Take hold of the sides of the oven door with both
1.
hands.
Slide the hinges into the slots in the oven (a).
2.
The notch at the bottom of the hinges must
Note:
engage into the frame of the oven (b).
Lower the door.
3.
Remove the locking pins.
4.
:
Warning – Risk of injury!
If the oven door falls out accidentally or a hinge snaps
shut, do not reach into the hinge. Call the after-sales
service.
:
Warning – Risk of injury!
The door may not close properly if the door hinges have
not engaged correctly. This will allow heat to escape
and the parts of the appliance may become very hot. To
prevent this from happening, remove the door again.
Then refit the door as shown in the drawing, making
sure that the groove on the underside of the hinges
engages in the oven frame.
Appliance door
en
19