Descargar Imprimir esta página

Midea MID45S120-ES Manual Del Usuario página 57

Publicidad

Idiomas disponibles

Idiomas disponibles

About the safety supply hose
The safety supply hose consists of the double walls. The system guarantees its
intervention by blocking the flow of water in case of the supply hose breaking
and when the air space between the supply hose itself and the outer corrugated
hose is full of water.
WARNING
Electrical Shock Hazard
A hose that attaches to a tap can burst if it is installed on the same water line as the
dishwasher. If your sink has one, it is recommended that the hose be disconnected
and the hole plugged.
How to connect the safety supply hose-
1. Pull the safety supply hoses out from storage compartment located at
rear of dishwasher.
2. Tighten the screws of the safety supply hose to the faucet with thread 3/4inch.
3. Turn the water fully on before starting the dishwasher.
How to disconnect the safety supply hose
1. Turn off the water.
2. Unscrew the safety supply hose from the faucet.
Connection Of Drain Hoses
Insert the drain hose into a drain pipe with a minimum diameter of 4 cm, or let it run into
the sink, making sure to avoid bending or crimping it. The height of drain pipe must be
less than 1000 mm. The free end of the hose must not be immersed in water to avoid
the back flow of it.
Please securely fix the drain hose in either position A or position B
Back of dishwasher
Mains Cable
Drain hose
Water Inlet
Drain Pipe
13
Drain Pipe
A
B
40 mm
Counter

Publicidad

loading