Publicidad
Idiomas disponibles
Idiomas disponibles
Fully-integrated model
Install the hook on the aesthetic panel and put the hook into the slot of the outer
door of dishwasher (see figure A). After positioning of the panel, fix the panel
onto the outer door by screws and bolts (See figure B).
A
Step 3. Tension adjustment of the door spring
1. The door springs are set at the factory to
the proper tension for the outer door. If
aesthetic panel are installed, you
will have to adjust the door spring tension.
Rotate the adjusting screw to drive the
adjustor to strain or relax the steel cable.
2. Door spring tension is correct when the
door remains horizontal in the fully opened
position, yet rises to a close with the slight
lift of a finger.
Step 4. Dishwasher installation steps
Please refer to the specific installation steps in the installation drawings.
1. Affix the condensation strip under the work surface of cabinet. Please ensure the
condensation strip is flush with edge of work surface. (Step 2)
2. Connect the inlet hose to the cold water supply.
3. Connect the drain hose.
4. Connect the power cord.
5. Place the dishwasher into the cabinet.
6. Level the dishwasher. The rear foot can be adjusted from the front of the
dishwasher by turning the Philips screw in the middle of the base of dishwasher
use a Philips screw driver. To adjust the front feet, use a flat screw driver and turn
the front feet until the dishwasher is level. (Step 5 to Step 6)
7. Install the furniture door to the outer door of the dishwasher. (Step 7 to Step 10)
8. Adjust the tension of the door springs by using a Philips screw driver turning in a
clockwise motion to tighten the left and right door springs. Failure to do this
could cause damage to your dishwasher. (Step 11)
1.Take away the four short screws
B
16
2.Pin up the four long screws
Publicidad
