Publicidad
Idiomas disponibles
Idiomas disponibles
All synthetic material must be protected
from slag, hot sparks, open flames, or
other heat sources. The use of heat resis-
tant materials is recommended in these
applications.
Do not allow equipment to come in contact
with anything that will damage it including,
but not limited to, sharp, abrasive, rough or
high-temperature surfaces, heat sources,
electrical hazards, or moving machinery.
Do not expose the equipment to any hazard
which it is not designed to withstand.
Consult the manufacturer in cases of doubt.
Never remove product labels, which include
important warnings and information for
the authorized person/user.
2.2 Warnings and Limitations
Capacity
For use by ONE person only. Maximum
capacity for Miller Self-Retracting Lifelines
is 420 lb (190.5 kg), including body weight,
clothing and tools. Refer to the product
labels on the Self-Retracting Lifeline and
the performance specifications provided in
the Product Identification, Specifications
and Labels section of this manual. (See
APPENDIX B)
ANSI capacity range is 130 lb- 310 lb (59
kg - 140.6 kg).
System Compatibility
Honeywell Miller fall protection products
are designed for use with Honeywell-
approved components only. Substitution
or
replacement
component combinations or subsystems,
or both, may affect or interfere with the
safe function of each other and endanger
the compatibility within the system. This
incompatibility may affect the reliability
and safety of the total system.
WARNING
Always refer to the regulations and
standards regarding personal fall
arrest system component require-
ments and the instructions provided
with each component being used as
part of the personal fall arrest system.
with
non-approved
Anchorage Requirements
The anchorage must be capable of
supporting 5,000 lb (22.2kN) per worker;
or it must be designed, installed, and used
under the supervision of a qualified person
as part of a complete fall arrest system
which maintains a safety factor of two.
ANSI anchorage requirements are as
follows:
• For fall arrest systems, anchorages
must withstand a static load of
5,000 lb (22.2 kN) for non-certified
anchorages
maximum arresting force for certified
anchorages.
• When more than one personal fall
arrest system is attached to an
anchorage, the above anchorage
strengths must be multiplied by the
number of personal fall arrest systems
attached to the anchorage.
Limits of Use
Self-Retracting Lifelines are designed for
fall arrest applications only. Never use an
SRL as a restraint or positioning device.
For G2 twin connector: Use only Honeywell-
approved
compatible
Lifelines - Personal, with this device.
IMPORTANT!
A fall restraint scenario could occur
anytime:
The user fully extends the lifeline
and applies weight or stress to that
lifeline.
The user intentionally or unintentionally
locks up the lifeline, without the lifeline
fully extended, and applies weight or
stress to that lifeline.
The correct application for using an
SRL allows the user to be connected
and move freely to perform the
required work tasks without locking
the lifeline or applying tension on
the lifeline at full extension.
Anchor device vertically overhead whenever
possible. For the purposes of this instruc-
tion manual, an overhead application
implies that there is no slack in the lifeline
when the unit is mounted above the user
and connected to the user's back D-ring.
For suitability in other installation applica-
tions, refer to section 3.0 Installation/Use.
7
or
two
times
Self-Retracting
the
Publicidad
